Quantitative cell lysis of indigenous microorganisms and rapid extraction of microbial DNA from sediment.

This study reports improvements in two of the key steps, lysis of indigenous cells and DNA purification, required for achieving a rapid nonselective protocol for extracting nucleic acids directly from sodium dodecyl sulfate (SDS)-treated sediment rich in organic matter. Incorporation of bead-mill homogenization into the DNA extraction procedure doubled the densitometrically determined DNA yield (11.8 micrograms of DNA.g [dry weight] of sediment-1) relative to incorporation of three cycles of freezing and thawing (5.2 micrograms of DNA.g [dry weight] of sediment-1). The improved DNA extraction efficiency was attributed to increased cell lysis, measured by viable counts of sediment microorganisms which showed that 2 and 8%, respectively, survived the bead-mill homogenization and freeze-thaw procedures. Corresponding measurements of suspensions of viable Bacillus endospores demonstrated that 2 and 94% of the initial number survived. Conventional, laser scanning epifluorescence phase-contrast, and differential interference-contrast microscopy revealed that small coccoid bacterial cells (1.2 to 0.3 micron long) were left intact after combined SDS and bead-mill homogenization of sediment samples. Estimates of the residual fraction of the fluorescently stained cell numbers indicated that 6% (2.2 x 10(8) cells.g [dry weight] of sediment-1) of the original population (3.8 x 10(9) cells.g [dry weight] of sediment-1) remained after treatment with SDS and bead-mill homogenization. Thus, lysis of total cells was less efficient than that of cells which could be cultured. The extracted DNA was used to successfully amplify nahR, the regulatory gene for naphthalene catabolism in Pseudomonas putida G7, by PCR.(ABSTRACT TRUNCATED AT 250 WORDS)     

Superposition properties of interacting ion channels.

Quantitative analysis of patch clamp data is widely based on stochastic models of single-channel kinetics. Membrane patches often contain more than one active channel of a given type, and it is usually assumed that these behave independently in order to interpret the record and infer individual channel properties. However, recent studies suggest there are significant channel interactions in some systems. We examine a model of dependence in a system of two identical channels, each modeled by a continuous-time Markov chain in which specified transition rates are dependent on the conductance state of the other channel, changing instantaneously when the other channel opens or closes. Each channel then has, e.g., a closed time density that is conditional on the other channel being open or closed, these being identical under independence. We relate the two densities by a convolution function that embodies information about, and serves to quantify, dependence in the closed class. Distributions of observable (superposition) sojourn times are given in terms of these conditional densities. The behavior of two channel systems based on two- and three-state Markov models is examined by simulation. Optimized fitting of simulated data using reasonable parameters values and sample size indicates that both positive and negative cooperativity can be distinguished from independence.     

Until death do us part? In-depth insights into Dutch consumers’ considerations about product lifetimes and lifetime extension

Long-lasting electronic products contribute to a sustainable society; however, both expected and actual lifetimes are in decline. This research provides in-depth insights into consumers’ considerations about product lifetimes, barriers to extending lifetimes, and responses to a product lifetime label. Results of interviews (n = 22) with Dutch consumers suggest a positive view on long-lasting products. Nevertheless, their products’ value depreciated during their lifetimes. Consumers consider themselves unable to estimate how long products should last, which can be detrimental as low expectations tend to negatively influence actual lifetimes. Also, use intensity and consumers’ care(less) behavior influence the lifetime. To extend product lifetimes, consumers often disregard the option of repairing malfunctioning products. They have limited knowledge and ability, and believe repair provides poor value for money. Lifetime extension can also be hindered by market-related factors, such as convenient replacement services, new technological developments, and (attractive) deals. We suggest a product lifetime label should contain relevant and reliable information; furthermore, we recommend including (extended) warranty information. When information about repairability is included, potential negative responses should be considered. Finally, raising awareness about the environmental impact of short-lived products via a label may have a positive effect but requires more research attention.     

Parthenogenesis in an elasmobranch in the presence of conspecific males

Parthenogenesis has been observed in several elasmobranch species, primarily in public aquaria. The majority of cases of parthenogenesis have occurred either when females were held without males or once a male was removed from a female's habitat. Here we report a second instance of parthenogenesis in a zebra shark female that was housed with conspecific mature males. This study calls into question the conditions under which elasmobranch females undergo parthenogenesis.     

Improved pulse sequences for measuring coupling constants in 13C, 15N-labeled proteins

Summary NMR pulse sequences for measuring coupling constants in ¹³C, ¹⁵N-labeled proteins are presented. These pulse sequences represent improvements over earlier experiments with respect to resolution and number of radiofrequency pulses. The experiments are useful for measuring J_NH , J_NCO, J_NC , J_H ^N _CO and J_H ^N _H . Applications to chymotrypsin inhibitor 2 (CI-2) are shown.     

Importance of canopy structure on photosynthesis in single- and multi-species assemblages of marine macroalgae

Plant communities utilize available irradiance with different efficiency depending not only on their photosynthetic characteristics but also on the canopy structure and density. The importance of canopy structure are well studied in terrestrial plant communities but poorly studied in aquatic plant communities. The objective of this study was to evaluate macroalgal community photosynthesis in artificial constructed communities of one to four species with different morphologies along a range of leaf (i.e.=thallus) area densities. In a laboratory set-up we measured net photosynthesis and dark respiration in constructed assemblages of macroalgae, excluding effects other than photosynthesis of individual tissue and distribution of photons in the canopy from influencing metabolism. We hypothezised that 1) canopy structure determines the actual rates of photosynthesis relative to the optimal rates and 2) multi-species communities attain higher maximum photosynthetic rates than single species communities. We found that differences in canopy structure outweighed large differences in tissue photosynthesis resulting in relatively similar maximum community photosynthetic rates among the different single and multi-species assemblages (20.1–40.5 μmol O₂ m⁻² s⁻¹). Canopy structure influenced community photosynthesis both at low and high leaf area densities because it determines the ability of macroalgae to use the photosynthetic potential of their individual tissues. Due to an averaging effect the photosynthetic rate at high leaf area density was more similar among multi-species community than among single-species communities. Multi-species communities had, on average, a slightly higher photosynthetic production than expected from photosynthesis of single species communities. Moreover multi-species communities were capable of exposing new tissue to irradiance up to high densities thereby avoiding a decrease in net photosynthesis. This finding suggests that multi-species communities may be able to maintain higher biomass per unit ground area than single-species communities.